$265.00

Fabtech Hummer H2 Heavy Duty Tie Rods
[FTS71002]

Fabtech Hummer H2 Heavy Duty Tie Rods

Add to Cart

Date Added:

by G.T. Sanford III

If you actually get out and look at the stock H2 tie rods, you will ask yourself how Hummer justifies such an inadequate design. The stock tie rods are 0.5 inch in diameter, and have been known to bend and break.

These Fabtech tie rods are just what the doctor ordered. They are beefy and stout - just like the H2. They are almost the same diameter as the sway bar! Something else will break before these babies.

Installation was easy, taking about 1.5 hours for both. Standard shop tools are all that are required. Removing the original tie rods and installing the new ones was accomplished without jacking up the H2. The length of each rod was adjusted and tested for fit. When they slid in easily, they were tightened down in place. This sequence assured that the front-end alignment was not too far out, so it was safe to drive to an alignment shop for a full front-end alignment.

Even though Fabtech states that these tie rods are only for use with their lift kit, they work just fine on stock H2's.

I highly recommend this product.

Rating: 5 of 5 Stars! [5 of 5 Stars!]

Write Review Back
Manufacturers
Quick Find
 
Use keywords to find the product you are looking for.
Advanced Search
0 items
Manufacturer Info
Fabtech
Other products
Share Product